BHBikes ATOM - Battery Charging Process

EN
ATOM USER MANUAL
45
Battery Charging Process
Due to its advanced lithium-ion technology, there is no need to wait for the battery to completely discharge before
connecting it to the charger. Likewise, it is also not necessary to charge it to 100% before using it again. But bear
in mind that, in order to achieve a maximum operating range, a full charge is recommended.
WARNING
Turn off the pedal assistance system before removing the battery from
the bicycle.
Use both hands to remove the battery, taking special care not to drop it.
Dropping the battery on your foot could cause injury and may damage
the battery.
• To remove and charge the battery integrated into the frame, follow the instructions below:
1. The user must open the lock that is on the frame, below the built-in battery.
2. The user should carefully slide the battery out by twisting it slightly.
ES
M A N U A L D E L U S U A R I O
12
Charger
Charger
Battery port
External port
External port
Battery port
1º
1º
2º
2º
Charger
Charger
Battery port
External port
External port
Battery port
1º
1º
2º
2º
STANDBY
CHARGING
CHARGING PROBLEM
100% CHARGED
WARNING
Turn off the pedal assistance system before starting to charge it from
the charging port of the bicycle.
• To charge the battery integrated into the frame using the charging port of the bicycle, follow
the instructions below:
1. The user must locate the charging port of the bicycle.
2. Theusermustplugintheextensioncableofthecharger,whichwilltintothecharging
port of the bicycle.
ES
M A N U A L D E L U S U A R I O
12
Charger
Charger
Battery port
External port
External port
Battery port
1º
1º
2º
2º
Charger
Charger
Battery port
External port
External port
Battery port
1º
1º
2º
2º
STANDBY
CHARGING
CHARGING PROBLEM
100% CHARGED