EasyManua.ls Logo

Bialetti Area - Loading Capsules

Bialetti Area
84 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English
9
54
Close the capsule loading tray. The machine activates the
warm-up phase to perform the cleaning cycle. The display
will show:
The following message is displayed:
The brew group and the Cappuccinatore - if it is inserted -
will dispense hot water. The cycle cannot be interrupted.
Then the machine is ready for use.
If you select No, the machine activates the warm-up phase
and - once completed - it will be ready for operation.
Upon product dispensing the machine may perform a
warm-up cycle, if necessary. The display will show:
9.2 Rinsing and Self-cleaning
The cycle allows the coffee and milk circuits to be rinsed
with fresh water.
The machine requests to perform this cycle during the
warm-up phase only, in the following cases:
Upon machine start-up, when it is cold.
During the stand-by preparation phase, if at least one
coffee-based or milk-based product has been brewed.
9.3 Loading Capsules
Only BIALETTI
PROFESSIONAL capsules
should be used to brew
the desired products.
Capsules other than
non-original BIALETTI
PROFESSIONAL capsules,
coffee beans, ground
and/or freeze-dried coffee
should never be used.
The capsules supplied for
this machine are single-use
capsules and each of them
should be used for one
brewing cycle only.
Capsules should not be
reused to brew two or
more products.

Related product manuals