21
KNOMI UI
1. Tap .
2. Turn the temperature dial clockwise or counter-clockwise to change the setting.
4. Tap , keep your finger on the screen, and adjust the length and speed by scrolling the respective bars up and down until you reach your
5. Tap or .Your printer will start Extruding or Retracting.
preferred values, release your finger and tap . KNOMI 2 will automatically return to the Extruding/Retracting Filament interface with the new
value selected.
3. When you've picked the temp you want, tap and you'll go back to the Extruding/Retracting Filament interface with the new value selected.
* While on the temperature adjustment dial, you can return to the Extruding/Retracting Filament interface by swiping up
from any spot.
To Next Page
Loading...