•
Press the UP arrow key to enter the count up function and the clock displays 00:00:00 or the
previous time that was set.
•
Press “Set/Save” key to set time: Press the number keys to change blinking digits and press
left arrow or right arrow key to move between hours, minutes, seconds. While the finished
setting is still blinking press the F4orF5or F3 key to store the program for future use-if desired
(If no storage is required just press Set/Save) and then press Set/Save to save data and exit
the setting. Or press the “Exit” key to exit setting without saving.
•
When entering Count up mode the clock shows00:00:00. To see the value already stored press
Set/Save
•
To view the value stored in F3, F4, F5 press any of these keys and 00:00:00 will show. Press
Set/Save to view value
•
If desired Press REPEAT to set or cancel automatic repeat of the program
•
If desired press READY to set or cancel 10 second countdown preparation time
•
Press “OK” key to start the function or to stop.
•
When the program has finished and the digits are flashing press the OK arrow key again to
stop flashing immediately
•
While the count up function is working, you can press the “Shift” key to glance at the time for
3 seconds ( the count up function continues to run)
•
Press SW to enter the Stopwatch function and the clock displays 00:00:00.
•
Press the “Reset” key or SW key to clear data when the stopwatch stops
•
Press the “OK” key to start the stopwatch or pause.
•
While the stopwatch is working, you can press the “Shift” key to glance at the time for 3
seconds ( the stopwatchcontinues to run).
To Next Page
Loading...