•
BUZZER MUTE CONTROL AND NUMBER OF BEEPS CONTROL.
Press the CANCELkey and one single digit will display.Set the number of beeps required and
press Set key to save.If the digit is set to 0 then this means the sound is muted. If you set
the digit to 1 then the buzzer beeps one time. Set it to two and it beeps 2 times and so on
from 1-9 ( Remember 0 is mute). Press setto store.
•
LOUDNESS OPTIONS
There are two loudness options for the internal buzzer using a switch on thesideof the
clockto change loudness.
•
FLASHING
The digits will flash indicating the end of the program
•
IF THE BUZZER IS ON, AN LED LIGHT AT THE BOTTOM RIGHT HAND CORNER WILL LIGHT.IF IT IS MUTED
THERE IS NO LIGHT
•
PROGRAM PREPARATION FUNCTION. PRESS F3 TO ADD OR CANCEL 10 SECONDS COUNTDOWN
PREPARATION ON EACH PROGRAM-COUNT UP, COUNTDOWN, INTERVAL-WHEN SELECTED THE
TRIANGLE LIGHT ON THE RIGHT LIGHTS UP. (If you use the program preparation function and the
overall sound is muted you will still hear a beep sound for the last 3 seconds of the
preparation when it beeps 3-2-1-start.)
•
WHEN AUTO REPEAT IS SELECTED (KEY F4 )THE COUNTDOWN OR COUNT UP PROGRAM FINISHES AND
THEN FLASHES AND BEEPS AND THEN REPEATS AGAIN AND SO ON-WHEN SELECTED THE STAR LIGHT
ON THE RIGHT LIGHTS UP.
•
TO ACCESS A STORED PROGRAM JUST PRESS THE F1-F8KEY IN WHICH IT IS STORED. THE CLOCK WILL
SWITCH AUTOMATICALLY TO WHATEVER FUNCTION THE STORED PROGRAM APPLIES TO.
•
WHEN THE REMOTE BATTERY IS TOO LOW, THE LED ON THE TOPOF THE REMOTE WILL FLASH. CHANGE
THE BATTERIES AT THAT TIME. REMOVE BATTERIES WHEN NOT USING THE CLOCK FOR A LONG TIME
To Next Page
Loading...