BigTimeClocks 180 - Setting Repeat Times (H3); Saving the Interval Program; Starting and Pausing Interval; Stopping Flashing Digits

!
Page ! of !7 9
•
Press “Set” key a third time and the clock displays H3 XX XX and the XX blinks. Enter the
number of times you want the program to repeat.
•
While the finished setting is still blinking press the F3 F7 or F8 key to store the program for
future use-if desired ( If no storage is required just press Set/Save) and then press Set/Save a
fourth time to save data and exit the setting
•
Press “OK” key to start or pause program.
•
When the program has finished and the digits areflashing press the OKkey again to stop
flashing immediately
•
While the interval timer function is working, you can press the “Shift” key to glance at the
time for 3 seconds ( the interval timer function continues to run)
•
Press SW to exit INTERVAL and switch to a new program (Countdown Count up etc)
13. COMBINATION MODE
This mode allows the clock to countdown to zero and then immediately count up from zero.
(This function allows you to see how much "overtime" has been used on an exercise)When the
countdown reaches zero it will flash/ buzzer sound according to your countdown settings and
immediately start counting up to the time limit which has been set.
Press the F9 key to enter the Combination Mode and the clock displays the Countdown Time
99:59:59 or the previous time that was set. Press Set/Save key to set Countdown Time.Press
the number keys to change the blinking digits and set the time and then press Set/Save to save
data and exit the setting. The Count up Time limit will then be displayed. Press the number
keys to change blinking digits and then press Set/Save to save data and exit the setting. (If you
want no limit set the time for 99:59:59 which is the maximum).
14. OTHER FUNCTIONS/OPTIONS
•
POWER OFF FUNCTIONS CONTINUE OPERATING
When the clock is in countdown/count up/interval/stopwatch mode if the power is cutoff the
function continues to count. e.g if a countdown is set for 15minute and power is cutoff at 13
minutes and then power is turned on again 1 minute later the clock will have continued the
countdown and show 14 minutes elapsed.