Shenzhen BIGTREE technology co., LTD.
BIG TREE TECH
6) Automatic shutdown after print
To make use of the automatic shutdown feature you need a BIGTREETECH Relay V1.0
module. See the user manual for the module for more information. You can find it here:
http://github.com/bigtreetech
Firmware
By default there will be a firmware installed on the board, which is optimized for Ender 3.
It is also possible to make changes to the firmware. You can find the needed firmware
files on our Github page.
BigTreeTech firmware: http://github.com/bigtreetech?tab=repositories
Marlin2.0 firmware update method:
After downloading the files, use Visual Studio Code to open the project for compilation.
Customize the firmware and compile it. Check for errors. If there are no errors, find the
firmware.bin file. Copy it to the SD card and plug the SD card in the board. Reboot the
board, wait for about 10 seconds before doing anything else with the board.
For detailed steps, please check this document:
http://www.dropbox.com/s/ppjfflhf3j5yzh2/MarlinV2.0%20SKRV1.1%20instruction.docx?
dl=0
Note: File name cannot be changed, firmware.bin must be lowercase!
9
To Next Page
Loading...
Need help?
General
