Need help?Do you have a question about the BIGTREETECH SKR-PRO-V1.2 and is the answer not in the manual?
General| Processor Speed | 168 MHz |
|---|---|
| RAM | 192KB |
| Operating Voltage | 3.3V |
| Endstops | 6 |
| USB Port | Yes |
| SD Card Support | Yes |
| File Format | G-code |
| Microcontroller | ARM Cortex-M4 series STM32F407ZGT6 |
| Input Voltage | 12V-24V |
| Stepper Driver Support | TMC2208, TMC2209, A4988, DRV8825 |
| Driver Interface | SPI/UART |
| Display Support | TFT, LCD12864, LCD2004 |
| Communication Interface | USB, UART |
| Supported Slicer Software | Cura, PrusaSlicer, Simplify3D |
| Firmware | Marlin |
Features an ARM Cortex-M4 series with a 168 MHz STM32F407ZGT6 chip for enhanced performance.
Microprocessor: ARM 32-bit Cortex-M4 CPU; Input Voltage: DC12V-DC24V.
Supports drivers like TMC5160, TMC2208, TMC2130, and driving modes TMC2130SPI, TMC5160SPI, TMC2208 UART.
Explains how to select the power source (USB or 12/24V) using jumper caps.
Illustrates the three-power supply connection method using a switching power supply.
Details USB connection, automatic driver installation, and verification via Device Manager.
Details support for Marlin2.0 firmware and provides a step-by-step update procedure.
To Next Page