Need help?Do you have a question about the BIGTREETECH MANTA E3EZ V1.0 and is the answer not in the manual?
General| Architecture | 32-bit |
|---|---|
| USB Port | 1 |
| Size | 100mm x 100mm |
| Thermistor Inputs | 5 |
| Endstops | 6 |
| Heater Outputs | 2 |
| SD Card Slot | Yes |
| Supported Drivers | TMC2209 |
| Input Voltage | 12V to 24V |
| USB Interface | Type-C |
| Firmware Compatibility | Marlin |
| Display | Supports TFT displays |
| Interfaces | I2C, UART, SPI |
Lists key technical specifications and capabilities of the motherboard.
Illustrates the physical layout and labels of the board's connectors.
Details the function and mapping of each pin on the motherboard.
Explains how to power the board using USB and the VBUS jumper.
Guides on selecting motherboard and motor supply voltages via jumpers.
Explains the onboard SPI and UART modes for EZ drivers.
Details jumper settings for sensorless homing using EZ drivers.
Guides on connecting the core board (CM4 or CB1) to the motherboard.
Instructions on downloading appropriate operating system images for CM4.
Guide to installing the Raspberry Pi Imager tool for OS flashing.
Steps for writing the OS image to a MicroSD card using Raspberry Pi Imager.
Instructions for installing the rpiboot utility for Windows, Mac, and Linux.
Details enabling the USB 2.0 Hub on the CM4 by modifying config.txt.
Instructions for setting up the DSI1 display interface for the CM4.
Guide to installing the CSI1 camera driver for the CM4.
Instructions for downloading OS images specifically for the BIGTREETECH CB1.
Guide to downloading and installing the balenaEtcher tool for OS flashing.
Guide to connecting to the device via SSH using Mobaxterm.
Instructions for updating firmware using an SD card.
Guide for updating firmware using the DFU (Device Firmware Update) method.
To Next Page
