Need help?Do you have a question about the BIGTREETECH SKR E3 DIP V1.0 and is the answer not in the manual?
General| Processor | ARM Cortex-M3 |
|---|---|
| Processor Speed | 72 MHz |
| Communication Interface | UART, SPI, I2C |
| USB Interface | USB 2.0 |
| SD Card Slot | Yes |
| File Format | G-code |
| Input Voltage | 12-24V DC |
| Motor Driver Support | TMC2208, TMC2209, A4988, DRV8825 |
| Endstop Connectors | 6x (X, Y, Z, E0, E1, Probe) |
| Heater Outputs | 2x (Hotend, Bed) |
| Fan Outputs | 2 |
| Display Support | LCD12864, TFT |
| USB Port | 1 |
| Supported Slicer Software | Cura, PrusaSlicer, Simplify3D |
| Compatible Firmware | Marlin |
Details the key functionalities and hardware aspects of the controller board.
Lists the physical dimensions, input voltage, and maximum power usage.
Configuration for STEP/DIR stepper driver mode, including jumper settings.
Configuration for SPI mode for TMC2130 and TMC5160 stepper drivers.
Configuration for UART mode for TMC2208 and TMC2209 stepper drivers.
Guide to updating the Marlin2.0 firmware via SD card.
To Next Page
