Shenzhen Big Tree Technology Co., Ltd.
BIGTREETECH
26 / 30
7. Login:
CM4:
Login as: pi
Password: raspberry
CB1:
Login as: biqu
Password: biqu
Compile MCU Firmware
1. After SSH is successfully connected to the device, enter in the terminal:
cd ~/klipper/
make menuconfig
Compile the firmware with the following configuration (if the options below are not
available, please update your Klipper source code to the newest version).
* [*] Enable extra low-level configuration options
* Micro-controller Architecture (STMicroelectronics STM32) --->
* Processor model (STM32G0B1) --->
* Bootloader offset (8KiB bootloader) --->
* Clock Reference (8 MHz crystal) --->
* Communication interface (USB (on PA11/PA12)) --->
To Next Page
Loading...
