Bil-Jax 45XA - 3 OPERATION

16
3 OPERATION
The Model 45XA Aerial Work Platform is equipped with multiple operator
control stations. Operators can use boom and outrigger functions from
both the platform and ground control panels. Drive functions are found
on the platform control panel.
Before attempting boom lift operation, Operators should:
 Attend a training program as required by government regulations.
 Obtain, read and obey all safety precautions as indicated by
manufacturer’s recommendations and all federal, state and local
regulations.
 Become familiar with the location and use of all controls.
 Verify that there are no overhead obstructions or live power sources
in the work area that could interfere with the safe operation of the
boom lift.
 Position the boom lift on a firm and level surface.
 Conduct a Pre-Operation inspection by performing all recommended
Daily Service Checks. Refer to Section 2.