4.8.2 Store a Redial Number into the Phonebook
1. Follow Steps 1 and 2 in section 4.8.1
.
2. Press <MENU> and <UP/DOWN> to select ADD TO PB.
3. Press <OK> and then enter the name you want to use in the phonebook.
4. Press <OK> and then modify the number, if necessary.
5. Press <OK> to show <MELODY 1>.
6. Press <UP/DOWN> to browse the ringtone list. The respective ringtone will
be played when browsing the ringtone list. (Note: the selected melody will
7. Press <OK> to confirm, and the entry will be stored.
only be played if you subscribe to Caller Display and the incoming number
matches the
stored number.)
4.8.3 Delete a Redial Number
1. Follow Steps 1 and 2 in section 4.8.1
.
2. Press <MENU> and <UP/DOWN> to select DELETE.
3. Press <OK> to confirm, and the entry will be deleted.
4.9 Find the Handset
You can locate the handset by pressing <PAGE> on the base station. All the
handsets registered to the base will produce the paging tone and show
4.8.4
Delete all Redial list entries
1. Follow Steps 1 and 2 in section 4.8.1.
2. Press <MENU> and <UP/DOWN> to select DELETE ALL
3. Press <OK> to display <CONFIRM?>.
4. Press <OK> to confirm. All entries will be deleted and the display will show
<EMPTY>.
<TALK OFF>
/<C> on any handset or <PAGE> on the base again.
Note: If there is an incoming call during paging, the phone will ring with the
4.10 Make an Internal Call (For Multi-handset Versions Only)
This feature is only applicable when there are at least two registered handsets
.
It allows you to make internal calls, transfer external calls from one handset to
incoming call instead of paging.
"PAGING" on the display. You can stop the paging by pressing <TALKON>/
another handset and make conference calls. If the called handset is not
answered within 60 seconds, the called handset will stop ringing and the calling
Note: If only one handset is registered to the base station, when <C/MUTE/INT>
is pressed, it will display
“
NOT POSSIBLE
”
handset will return to
standby mode.
13
To Next Page
Loading...
