Binatone iDECT C5i System - Advanced Phone Settings; Recall Time (Flash); Registration

24
Advanced phone settings
Recall time (Flash)
You may need to change the recall (flash) time if your phone is
connected to a PBX. Three options are available: Short (85ms),
Medium (100ms) and Long (250ms). The default is Medium, which is
the standard UK requirement.
1
m
Press MENU/OK m to enter the main menu.
2
.
Press UP u or DOWN d to select Advanced Set .
3
m
Press MENU/OK m to confirm.
4
m
Press MENU/OK m again to select Recall Time .
5
.
Press UP u or DOWN d to select Medium , Short or Long .
6
m
Press MENU/OK m to save your setting.
Registration
If you have purchased a iDECT C5i multi-handset system, all
handsets come pre-registered to the base unit. You do not need to
register them again. Handset registration is only necessary when you
buy extra handsets or if a handset has become faulty.
You can register additional handsets to have up to five handsets per
base unit, with each handset's number (1 to 5) shown on its display.
(Note: each handset can only be registered to one base.)
To register a handset to the base:
1
m
Press MENU/OK m to enter the main menu.
2
.
Press UP u or DOWN d to select Advanced Set .
3
m
Press MENU/OK m to confirm.
4
.
Press UP u or DOWN d to select Registration .
5
m
Press MENU/OK m to confirm.
Î The display shows Enter PIN _ _ _ _ .
iDect_C5i_IFU_EN_UK.book Page 24 Monday, November 30, 2009 11:54 AM