WR3000N 300M Wireless N Router
- 19 -
I. By PBC
If the wireless adapter supports Wi-Fi Protected Setup and the Push Button Configuration (PBC)
method, you can add it to the network by PBC with the following two methods.
Method One:
Step 1: Press the WPS/Reset button on the front panel of the Router.
)
Note:
When press and hold the WPS/Reset button for more than 5 seconds, you will reset the Router.
Step 2: Press and hold the WPS button of the adapter directly for 2 or 3 seconds.
Step 3: Wait for a while until the next screen appears. Click Finish to complete the WPS
configuration.
The WPS Configuration Screen of Wireless Adapter
Method Two:
Step 1: Press the WPS/Reset button on the front panel of the Router.
To Next Page
Loading...
