SPECIFICATIONS:
Maximum Fluid Pressure: 303 bar [4,400 psi]
Maximum Air Pressure: 6.8 bar [100 psi]
Gun Body: Forged Aluminum
Fluid Path: Stainless Steel
Fluid Seat: Tungsten Carbide Seat
Fluid Inlet Size: 1/4" NPS(m) Thread
Air Inlet Size: 1/4" BSP/NPS(m) Thread
Gun Weight: 490 g [17.28 oz.]
(without Tip, Aircap, Guard)
The following instructions provide the necessary
information for the proper operation and preventive
maintenance of the Binks AA4400M Air-Assist Airless
Spray Gun. Please read and understand all information
in this document in order to get the maximum
performance from your new AA4400M spray gun.
In the AA4400M spray gun, the paint or other material
to be sprayed is pre-atomized and forced through the
carbide tip by the typical 110-262 bar [1,600-3,800 psi]
fluid pressure (with capabilities up to 303 bar [4,400
psi]). As a result of the pre-atomizing, the final shaping
air supplied by the air cap produces an exceptionally
fine and even spray pattern. The result of this spray
pattern is an even finish that lends itself to products
that need an exceptionally fine finish with reduced
overspray and VOC emissions.
FLAT TIP REVERSIBLE TWIST TIP
1 bar [15 psi] is the maximum inlet air pressure for HVLP (1 bar [15 psi] max. for HVLP twist tip cap), or use 1.4-2.8
bar [20-40 psi] inlet air pressure for LVMP. The HVLP flat tip and twist tip air caps consume 230 L/m [8.3 SCFM] air
at their respective maximum inlet air pressures. The LVMP flat tip and twist tip air caps consume 368 L/m [13 SCFM]
at 2.1 bar [30 psi] inlet air pressure.
EN
SERVICE MANUAL
AA4400M
™
AIR-ASSIST
AIRLESS SPRAY GUN
77-2922-R11 (5/2018) 1 / 16 www.carlisleft.com
To Next Page
Need help?
General
