Running Protocols
Tech Support: 1-800-4BIORAD • 1-800-424-6723 • www.bio-rad.com 5-9
Using the Instant Incubation Feature
The DNA Engine cycler may be converted to a constant-temperature incubator by
pressing «Instant Incubate». A screen allowing use of the heated lid will be displayed:
Use the «Select» keys to enable or disable the heated lid, then press «Proceed». A screen
allowing entry of the incubation temperature will be displayed.
Use the keypad to enter any incubation temperature from –5.0° C to 105.0° C, then
press «Proceed». The DNA Engine cycler will incubate the sample at the specified tem-
perature until «Cancel» or «Stop» is pressed.
When the sample block reaches the incubation temperature, a timer begins running in
the lower right-hand corner of the screen. To stop and start the timer, press «Pause».
4 Tip: The Pause feature is useful if you need to temporarily remove samples that must be
incubated for a precise period of time. Pausing the timer while samples are not in the
block allows you to track the exact duration of their incubation.
INCUBATE:
Use heated lid?
Yes _No
INCUBATE:
1= 20.0 for ever
Use heated lid?
Yes _No
To Next Page
