DNA Engine Operations Manual
6-18 Tech Support: 1-800-4BIORAD • 1-800-424-6723 • www.bio-rad.com
Revising During Programming
To change values in a program you are entering, follow the procedures described below.
This editing method should be used to change just a few values at a time. To make many
changes, or to delete or add entire steps, use Edit mode (see chapter 7).
To Change the Last Value Entered or Menu Option Chosen
Press «Cancel». The choice just made will be cancelled, so that another value may be
entered or another menu option chosen. Press «Proceed» after changing a value, so that
the program will accept it.
To Change All the Values in the Step Being Entered
Repeatedly press «Cancel». Each time you press the key, the cursor will move backward
through the values for the step, deleting the values as it moves. When all values for the
step have been deleted, enter new values, or press «Cancel» one more time to display
the Enter Menu for the step. At this point you can change the step to a different type.
To Change Values for Earlier Steps in the Program
Repeatedly press «Cancel» until the Enter Menu for the step you are working on is displayed.
Press «Cancel» one more time to display a list of all steps entered so far. The list will
show the step number and the values for each step, including any options chosen. The
last-entered steps will be displayed first:
At this point, you can choose to change selected values in program steps, to add an
option, to enter Edit mode, or to delete the entire program.
Press the «Select» keys to scroll through the program. The left «Select» key moves the
cursor backward through the steps, and the right «Select» key moves it forward.
• To change selected values or add an option: To change a value, move the
cursor to it, then press «Cancel». Enter the new value, then press «Proceed». If you
change your mind, press «Cancel» again; the deleted value will be restored.
Enter: CUSTO M 1
3= 55.0 for 0:30
4= 72.0 for 1:00
5=
To Next Page
