BIOSUN-340_(Anglais) - DOC012466 - Ind. B03 - 21/06/2017 Copyright BIO-UV
Marque, Modèles et Brevets déposés - Produits exclusifs
Page 4
B. SAFETY WARNINGS
• Switch off the device 10 minutes before any intervention to let the lamps cool down.
• Stop the system in the event of a prolonged stop of the water flow
• Never expose yourself to the radiation of the ultraviolet lamps when lit. This may
cause severe injuries or burns and may even lead to loss of eyesight.
• When the lamps are running, do not take the lamps of the reactor out or remove the
protection covers
• When dismounting UV lamp or quartz tube, it is necessary to wear protection gloves not
to let fingerprints that could affect the UV emissions quality
• Do not use the reactor if the power supply wire is worn or damaged. In this case it
should be replaced.
• To avoid electric short-circuits, do not place the electric wires or the reactor in the pool
water or in any other maintenance or cleaning fluid.
• Do not perform electrical measurement on ballast output (risk of overvoltage)
• Never disconnect solar panels during the charge
• Never unscrew the quartz tube sealing nut when the reactor is on load as the quartz
tube could be blown out of the reactor with force and injure you.
• In
case of a microleakage, the reactor must be isolated and drained to perform
maintenance as soon as possible.
• Do not use the BIO-UV reactor for any other use than that for which it was designed.
To Next Page
Loading...
