BioCool BIO-30 DAV - Problems and Solutions

PROBLEM COMMON CAUSES POSSIBLE SOLUTION
The evaporative cooler doesn’t work
and the buons do not respond
External switch (machine base) or interior switch off, power failure,
bad connection, blown fuse, loss of connection between the control
box and the machine, faulty remote controls..
Check that the switches are on, measure the voltage, and connect properly, reset or replace it, check connections,
replace the control panel. If it happens again, you should check again if there has been an overload.
No airflow
Warming up the engine, loss of electrical connections, damaged
contact, pre-cooling mode on, faulty remote controls .
If overheating engine will start aer 20 m. If the connection failures, check all electrical connections, if the contact
is broken, replace it, if pre-cooling function is ON, turn off this function temporarily, if the remote control is defective
must be replaced, if the engine is damaged must be changed. Check the parameters of voltage and current.
Pump is working but doesn’t cool well.
The cooling pads are dirty, insufficient air supply, dry pads or lack of
water, excessive moisture in the atmosphere..
If the problem are the pads, clean or replace, install grilles for the air in the places that need cooling, if the pads are
dry, check water distribution and the tank for possible obstruction, if there is excessive humidity in the atmosphere,
the evaporative doesn’t work at 100% because it works beer with drier climate. If desired, turn off cooling mode
in such days and turn on fan only..
Pump fails
Broken water pump, loss of electrical connection, water level sensor
is broken or damaged, faulty remote controls.
If the pump is broken must be replaced, failed connection, if there is no water check valves and tank, if your remote
control is defective must be replaced.
Pump is working but no water flows Water pump is blocked, water valve is locked, water supplier is locked.
If there is a pump blockage should be cleaned, if there is a valve blockage clean it, if the water supplier is locked
clean it..
Cleaning mode is activated too many
times or too much water flows.
Self-cleaning function is activated, faulty valve, the drain valve is
leaking, faulty remote controls.
If the self-cleaning function is enabled, temporarily disable, if the valve is obstructed or faulty, cleaning or changing,
if the drain valve leaks, check or replace the valve, if the remote control does not work, replace it.
Water drips on the inside
The pads are broken or blocked, excessive amount of water in the
pads.
If the pads are dirty or damaged, clean or replace, if there is excess water probably the water distributor is
unbalanced, balance it.
Smells The evaporative is with dirt. Clean the evaporative cooler completely
White residue High levels of salt in water. Drain water more frequently.
Red flashing on the remote control.
Erro de comunicação
Check the instructions in the BIOCOOL Control manual.
Erro de preenchimento
Erro de esvaziamento
Erro de motor
The communication green LED on the
electronics does not light up
Short-circuit in the communication cable, damage to the electrical
system and lack of power supply.
Change communication cable, check power supply or replace electronics.
PROBLEMS AND SOLUTIONS
ECO Cooling Soluons
36
>
37
>