When the button is pressed, and
no light signal appears.
The smartdot™ transmitter is not
switched on.
It hasn’t yet been charged for the
rst time or it has been reset.
What do I see?
What does it mean?
When does this light signal
appear?
What should I do?
No signal
1. Switch on the smartdot™
transmitter by plugging and
unplugging it once with the
charging cable, when connected
to an external power supply.
2. See steps C-E in ‘Part 5:
Preparing.’
3. Activate your transmitter. See
‘Part 5: Preparing <E. Activating
your smartdot™ transmitter’.
Continued on the next page
Part 9: Troubleshooting guide
24
To Next Page