biodex 950-192 - Set-up and Operation; Unpackaging and Assembling the medBike

12 Biodex Medical Systems, Inc. © 2017
2. Set-up and Operation
Unpackaging and Assembling the medBike
Your medBike will require a minimal amount of assembly. The only tool required is an Allen
wrench; provided within the packaged contents.
Figure 2.1. medBike--packaged contents.
Begin by removing the medBike’s main pedal/motor assembly from the packaging. From inside
the tube opening (just above the knob), you will see the cable that connects the display to the
motor.
The cable will have a guide wire that can be used to move the cable up through the handlebar
stem tube. When this is complete, place the tube into the pedal/motor assembly opening, and
affix the tube with a bolt using the Allen wrench.
Use the guide wire to move the display cable up through the handlebar stem tube (Figure 2.2),
and use the Allen wrench to affix the handlebar stem tube to the pedal/motor assembly (Figure
2.3).