Electrocardiograph (Ver 1.0)
6 Operational Do
’
s and Don
’
ts Operational Do
’
s and Don
’
ts 7
BCM-600
Operational Do
’’
s and Don
’’
ts
Do not operate or store the equipment under the following environments.
Locations exposed to chemical
or explosive gases.
Disassembling of equipment
should be done only by authorized
personnel, otherwise we will not be
required to provide, any services.
When pulling out the power cord,
be sure to hold the plug and pull,
not the cord.
Do not plug in the power unit,
until installation is completed,
otherwise, damage may be caused
to the equipment.
Make sure to prevent dust, especially
metal debris, from penetrating in.
Avoid damp locations, and do
not operate the equipment with
wet hands.
Locations where the temperature
fluctuation is rather large.
(Operational temperature range:
10~45℃(C, Moisture level : 30~85%)
Locations where moisture level
increase considerably or where
air is not ventilated properly.
Locations where sudden impact
or vibration could be received.
Locations close to electrical
heating apparatuses.
Locations where the machine is
exposed to direct sunlight.
Standard operational conditions are as follows.
Temperature : 10℃ ~ 45℃ (50 ~ 113℉)
Altitude : 70 ~ 106kpa
Humidity : 30 ~ 85%
Standard storage and transportation conditions are as follows.
Temperature : -10℃ ~ 50℃ (14 ~ 122℉)
Altitude : 70 ~ 106kpa
Himidity : 20 ~ 95%
To Next Page
