2.3 Inserting the Batteries
Follow these steps to insert four “AAA” batteries in the device.
1. Open the battery compartment cover in the direction shown.
2. Insert four “AAA” batteries with the correct polarity as indicated.
3. Replace the battery compartment cover.
Attention!
• After the battery warning
appears, the device is blocked until the batteries have been replaced.
• Please use “AAA” Long-Life or Alkaline 1.5V batteries.
• If the blood pressure monitor is left unused for long periods, please remove
the batteries from the device.
• Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc)
or rechargeable batteries.
2.4 Using the AC/DC Power Adapter
You may also operate this monitor using the included AC/DC adapter.
Use only the included adapter to avoid damaging the unit.
1. Ensure that the AC/DC adapter and cable are not damaged.
2. Plug the adapter cable into the AC/DC adapter port on the top of
the blood pressure monitor.
3. Plug the adapter into your electrical outlet. When the adapter is
connected, no battery current is consumed.
3. Using the Device
This section describes how to get the maximum benefit from your blood pressure monitor. Follow the instructions
carefully to get an accurate measurement of your blood pressure and pulse rate.
NOTE: Setting the user, year, month, date and time is one sequential process
3.1 Select the User
1. Start with the monitor OFF, but with batteries or adapter inserted.
2. Press the SET button twice, press the MEM button to switch between
User 1 and User 2.
To Next Page
Loading...
