1. When the monitor is OFF, press the SET button, 7D Mode will appear on the monitor. Press
the SET button to confirm.
NOTE: Press the MEM button to switch between 7D Mode and General Mode.
2. Next, select the user. When taking measurements in 7D Mode it is very important to select
the correct user. Press the SET button to confirm, then press the START/STOP button to
power the monitor OFF.
Preparation for measurement:
- Rest for 5 minutes before taking a measurement
- Sit at a table with your arm supported and legs uncrossed
- Avoid all movement and muscle tension
- Breathe normally and do not speak
- Wait at least 1 minute between consecutive measurements
- AM & PM measurements should be taken 10-12 hours apart
To start your measurement, see section 3.6 Measuring Your Blood Pressure. Once the Protocol is complete, after the 7
days, you can view your average. See section 3.8B Recalling Memory in 7D Mode.
IMPORTANT:
It is critical that users follow the measurement protocol carefully to ensure reliable data for diagnosis.
1. Take 2 measurements in the morning (ideally after going to the bathroom and before eating or drinking).
2. Take 2 measurements in the evening approximately 10-12 hours after the morning measurements, and ideally not
immediately after the evening meal.
3. Repeat these 4 measurements per day for 7 days consecutively.
NOTE 1: Missing measurements will cause ERR to appear on the display. Continue with the sequence of
measurements and discuss with your doctor when you review the data.
NOTE 2: The machine only recognizes AM and PM readings each day. It does not exclude AM and PM
measurements only a few hours apart. Each measurement has a time stamp. Discard any measurements
that were not at least 6 hours apart with your doctor.
3.5 General Mode
In General Mode, a user can take blood pressure measurements outside of the Protocol
Software (7D Mode).
1. When the monitor is OFF, press the SET button, 7D Mode will appear on the monitor. Press
the MEM button to switch between 7D Mode and General Mode. Press SET to confirm.
2. Next, select the user. Press SET to confirm, then press START/STOP button to power off
the monitor.
3. To start your measurement, see section 3.6 Measuring Your Blood Pressure.
3.6 Measuring Your Blood Pressure
After the cuff has been appropriately positioned, and the correct mode has been selected, the measurement can
begin:
Mode
7D
Mode
General
To Next Page
Loading...
