1. Press the START/STOP button until all the symbols appear on the screen. You will hear 2 short beeps and after
“ ” will flash for 2 seconds. The pump then begins to inflate the cuff. The increasing pressure in the cuff is shown
on the display.
2. After the suitable pressure has been reached, the pump stops and the cuff gradually deflates. The cuff pressure
will then be displayed. In case the initial inflation is not sufficient, the device automatically re-inflates to a higher
pressure.
3. When the device detects a heartbeat, the heart symbol “ ” on the display starts to flash for every heartbeat.
4. When the measurement has been completed, you will hear a long beep and the systolic, diastolic and pulse rate
will appear on the display.
5. The measurement readings remain on the display until you switch off the device. If no button is pressed, the device
switches itself off in 3 minutes.
NOTE: The symbol “ ” will be displayed along with the reading if irregular heartbeat has been detected during the
measurement. If the “ ” symbol appears frequently (e.g. several times in a week), it may be an indication of a more
serious heart problem, and you should consult your doctor.
3.7 Discontinuing a Measurement
To stop the measurement (eg. the patient feels unwell) press the START/STOP button. The device will immediately
decrease the cuff pressure automatically.
3.8 Memory Recall
This blood pressure monitor automatically stores 90 measurements for each user in its memory. The 90 memories are
split between the two modes: 28 memories in 7D Mode and 62 memories in General Mode. The oldest record will be
replaced by the latest measurement value when there are more than 90 sets for each user.
3.8A Recalling Memory in General Mode
First select General Mode, then turn the monitor OFF by pressing the START/STOP button. While the monitor is OFF,
press the MEM button to see the most recent measurement value. Subsequent measurements can be displayed one
after the other by continuously pressing the MEM button.
mmHg
AM
SYS
DIA
mmHg
PUL
/min
Mode
General
mmHg
AM
SYS
DIA
mmHg
PUL
/min
Mode
General
mmHg
AM
SYS
DIA
mmHg
PUL
/min
Mode
General
3.8B Recalling Memory in 7D Mode
First select 7D Mode, then press the START/STOP button to turn the monitor OFF. While the monitor is OFF, press the
MEM button.
A. If the Protocol was done correctly, the monitor will display “
”, meaning all 28 measurements have been
saved in the memory, and then display the Average Measurement as per the Protocol software. In the Average
Measurement screen the date will display the second day the Protocol measurements were started and then
change to the 7th day the Protocol measurements ended.
For example: If the first day of measurements are started on October 10th and ends 7 days later on October 17th,
the date will appear as 10M11D then change to 10M17D and back and forth . 10M11D will display instead of 10M10D
To Next Page
Loading...
