G41D3+/G41D3G+ BIOS Manual
15
USB Device Wakeup from S3/S4
This item allows you to enable or disabled the USB resume from S3/S4 function.
Options: Disabled (Default) / Enabled
High Performance Event Timer
This item allows you to enable or disabled the HPET.
Options: Disabled (Default) / Enabled
HPET Memory Address
This item allows you to set the memory address of HPET.
Options: FED00000h (Default) / FED01000h / FED02000h / FED03000h
Resume On Ring
This item allows you to control the wake on ring function.
Options: Disabled (Default) / Enabled
Resume On PME#
When you select Enabled, a PME signal from PCI card returns the system to Full ON
state. For this function to work, you may need a LAN add-on card which supports
the Wake on LAN function. Set the Wake on LAN (WOL) jumper on motherboard
to enable if applicable.
Options: Disabled (Default) / Enabled
Resume On RTC Alarm
When “Enabled”, you can set the date and time at which the RTC (real-time clock)
alarm awakens the system from Suspend mode.
Options: Disabled (Default) / Enabled
RTC Alarm Date (Days)
You can choose which date the system will boot up.
RTC Alarm Time
You can choose the system boot up time, input hour, minute and second to specify.
To Next Page
Loading...
