CHAPTER 1: INTRODUCTION
1.1 B
EFORE YOU START
Tha nk you for choo sing our product. Before you sta rt installing the
mo the rboa rd , plea se make sure you fo llo w the instructio ns be low:
Prepare a dry and stable working environment with
s ufficie nt ligh ting .
Always disconnect the computer from power outlet
before ope ra tion.
Befo re you take the mo the rboa rd ou t f rom a n ti-s ta tic
bag, ground yourself properly by touching any safely
grounded appliance, or use grounded wrist strap to
remove the static charge.
Avo id tou ch ing the compone nts o n m o the rboa rd o r the
rear side of the boa rd unless necessa ry. Hold the board
on the edge, do not try to be nd or flex the board.
Do no t lea ve any unfastene d small pa rts inside the
case after installation. Loose parts will cause short
circuits which may damage the equipment.
Keep the computer from dangerous area, such as heat
source, humid a ir and wa te r.
1.2 PACKAGE CHECKLIST
HDD Cable X 1
Se ria l ATA Cab le X 1
Rear I/O Panel for ATX Case X 1
User’s Ma nual X 1
Fully Setup Driver CD X 1
FDD Cable X 1 (optional)
USB 2.0 Cable X1 (optional)
S/P DI F out Ca ble X 1 (op tiona l)
To Next Page
Loading...
Need help?
General
