Biostar H510MX/E 2.0 User Manual

38 | 6. Tweaker Menu
tWRPRE
This item Holds DDR ming parameter tWRPRE. WR to PRE same bank minimum delay in tCK
cycles. Supported Range is 18-159.
Opons: Auto (Default)
tXP
This item Holds DDR ming parameter txP. Power up to any command minmum delay in tCK
cycles Supported Range is 4-16.
Opons: Auto (Default)
tXPDLL
This item Holds DDR ming parameter txP. Power up to RD / WR minmum delay in tCK cycles.
Applicable for DDR4 in case of exit from PPD when DRAM is congured to slow-exit mode.
Supported Range is 4-63.
Opons: Auto (Default)
tPRPDEN
This item Holds DDR ming parameter tPRPDEN. PRE to power down minmum delay in tCK
cycles. Suported Range is 1-3.
Opons: Auto (Default)
tRDPDEN
This item Holds DDR ming parameter tPRPDEN. RD to power down minmum delay in tCK
cycles. Supported Range is 4-95.
Opons: Auto (Default)
tWRPDEN
This item Holds DDR ming parameter tPRPDEN. WR to power down minmum delay in tCK
cycles. Supported Range is 4-159.
Opons: Auto (Default)
tCPDED
This item Holds DDR ming parameter tCPDED. Power down to command bus tri-state delay in
tCK cycles (for DDR4) supported Range is 1-7 in 1N mode.
Opons: Auto (Default)
tAONPD
This item Holds DDR ming parameter tAONPD. Supported range is 4-30.
Opons: Auto (Default)
tREFIx9
This item maximum me allowed between refreshes to a rank (in intervals of 1024 DCLK cycles).
Should be programmed to 8* tREFI/ 1024 (to allow for possible delays from ZQ or ISOC)
Opons: Auto (Default)
tXSDLL
This item delay between DDR SR exit and the rst command that requires data RD / WR from
DDR.
Opons: Auto (Default)
tZQOPER
This item denes the period required for ZQCL aer SR exit.
Opons: Auto (Default)
tMOD
The me between MRS command and any other command in DCLK cycles.
Opons: Auto (Default)

Biostar H510MX/E 2.0 Specifications

General

Brand	Biostar
Model	H510MX/E 2.0
Category	Motherboard
Language	English