Biostar TFORCE 550 - Page 21

TForce 550
19
JDDRII_2.2V : Header for Memory Voltage Overclocking
When processing Memory Voltage Overclocking, please place the jumper to
pin1-2 Closed. The Default setting is Pin 2-3 Closed.
1
3
Pin 1-2 Close:
Normal status (default).
1
3
1
3
Pin 2-3 Close:
Memory voltage Overclocking.
Note:
1. When “JDDRII_2.2V” jumper cap is placed on Pin 1-2, memory voltage
can be manually adjusted under CMOS setup.
2. When “JDDRII_2.2V” jumper cap is placed on Pin 2-3, memory voltage
will be fixed at 2.2V automatically, and can’t be adjusted under COMS
setup.
Before setting memory voltage overclocking, please ensure that your DDR
supports up to 2.2V. (Consulting your DDR2 memory module supplier)