english
|
21
1. Safety information
1.1 General remarks
These installation and operating instructions contain items of information of fundamental
importance which must be taken into account during assembly, operation and maintenance.
They should therefore be read without fail before installation and commissioning by the tter
and also the responsible specialist staff/operator. They must always be available for consul-
tation at the plant’s place of deployment. Not only are the general safety hints included in
this «Safety Hints» section to be observed, but also the special items of safety information
included in the other sections.
1.2 Identication of notices
Warning
The safety information contained in these instal-
lation and operating instructions, non-compliance
with which can lead to danger for people, are
specially marked with the general danger symbol
«Safety sign according to DIN 4844-W9».
Warning
This symbol is a warning of dangerous electric
voltage. «Safety sign according to DIN 4844-W8».
You will nd this symbol in the case of safety infor-
mation non-compliance with which can endanger
the machine and its functions.
Information signs mounted directly on the plant, such as, for example
– rotating direction arrow
– symbols for uid connections
must be obeyed without fail and be kept in a fully legible state.
1.3 Staff qualication and training
The staff deployed for assembly, operating, maintenance and inspection tasks must show that
they have the appropriate qualications for such work. The eld of responsibility, competence
and supervision of the staff must be stipulated exactly by the operator.
1.4 Risks in the event of non-compliance with the safety information
Non-compliance with the safety information can result in both danger for persons and also for
the plant and the environment. Non-compliance with the safety information can lead to the
loss of claims for damages of any kind.
To Next Page
Loading...
Need help?
General
