Birch CD-108E - Setup Deletion Configuration; Configuring Output Character Deletion

55
End Configuration
Save Configuration
Setup Deletion
To setup the deletion of output characters:
1. Scan the label of the desired set below.
2. Scan the label of the desired symboligy.
3. Go to the Decimal Value Tables in Appendix A, scan
label(s) that represents the desired position to be deleted.
4. Scan the "Complete" label of "Character Position to be
Deleted".
5. Go to the Decimal Value Tables in Appendix A, scan
label(s) that represents the number of characters to be
deleted.
6. Scan the "Complete" label of "Number of Characters to
b e Deleted".
Repeat the steps 1 - 6 to set additional deletion.
Select Deletion Set Number
1. 1st Set
2. 2nd Set
3. 3rd Set
4. 4th Set
5. 5th Set
6. 6th Set
%800+
%801+
%802+
%803+
%804+
%805+
Setup Deletion
Operation