Birch CD-108E - Setup Command Barcodes; Configuration Control Commands

9
Save Parameters
Save the parameter settings
permanently.
Recall Stored
Parameters
Replace the current parameters
by which you had saved last time.
Set All Defaults
Set all the parameters to
the factory default settings.
Start Configuration
End Configuration
Abort Configuration
Terminate current
programming status.
Version Information
Display the decoder version
information and date code.
%$ + / 0
%$ + / 1
%$ + / 2
%$ + / 3
%$ + / 4
%$ + / 6
%$ + / 5
Setup Commands