Directional RF Thruline® Wattmeter, Series 4410
17
RF Connectors Replacement
CAUTION
If other than Female N type connectors are used, limit power and frequency
to the capabilities of the RF coaxial cable or connectors used. Damage to
connectors or errors in reading could result.
1. Remove the four screws in the corners of the connector flange.
2. Pull the connector straight off carefully.
3. Replace the connector by reversing the procedure above.
Note: See Replacement Parts List for other available connectors.
Customer Service
Any maintenance or service procedure beyond the scope of those in this
chapter should be referred to a qualified service center.
If the unit needs to be returned for any reason, request an Return Material
Authorization (RMA) through the Bird Technologies website. All instruments
returned must be shipped prepaid and to the attention of the RMA number.
Bird Service Center
30303 Aurora Road
Cleveland (Solon), Ohio 44139-2794
Fax: (440) 248-5426
E-mail: bsc@birdrf.com
For the location of the Sales Office nearest you, visit our Web site at:
http://www.birdrf.com
Shipment
Should you need to return the power meter, use the original shipping package if
possible. If the original package is not available, use a heavy duty corrugated
box with shock-absorbing material around all sides of the unit to provide firm
cushion and to prevent movement in the container. The container should be
properly sealed.
To Next Page
Loading...
Need help?
General
