Bissell CrossWave HF3 User Manual

My CrossWave HF3 is leaking | Support
HF3™ Cordless Multi-Surface Wet Dry Vac
If your CrossWave HF3 is leaking, follow these
steps to solve the issue
Store machine with empty tanks
• Always store machine with both clean and dirty tanks empty to prevent leaking
Only use warm or lukewarm water
• If overheated water (over 140 ºF) is used > Damage will occur
• Use water directly from tap without heating
Check clean tank for damage
• Remove clean water tank

Bissell CrossWave HF3 Specifications

General

Brand	Bissell
Model	CrossWave HF3
Category	Ultrasonic Jewelry Cleaner
Language	English

Summary

Troubleshooting Leaking Issues

Store Machine with Empty Tanks

Always store the machine with both clean and dirty tanks empty to prevent leaks.

Use Appropriate Water Temperature

Only use warm or lukewarm water; avoid overheated water (over 140 °F) to prevent damage.

Inspect Clean Water Tank

Remove and inspect the clean water tank for damage, leaks, or warping.

Check Rubber Gasket and Tank Integrity

Inspect the rubber gasket for damage and the tank for cracks or warping. Replace if damaged.

Test Tank for Leaks

Fill the tank and hold over a sink to check for leaks from the inlet port.

Test Machine Operation

Recline the machine, turn it ON, and make several test strokes to check for the problem.