BT-350 Operation Manual
9
cause the finger wound. Also, do not prick the inside of BT-350 when the printer door
is open. This can cause damage to the device or electric shock.
0.3 Shock hazards
Do not attempt to connect or disconnect a power cord with wet hands. Make
sure that your hands are clean and dry before touching a power cord.
Do not attempt to disassemble the power adaptor with no permission. It may
cause an electric shock. Also, it has a low possibility of reaching to death. In the
case of you have some problems with the power adaptor, we recommend that
you have to contact to us first of all.
During upgrading the BT-350, do not use the BT-350 on the patient. This can
cause an electric shock to the patient.
Unplug the unit from its power source prior to cleaning or maintenance to
prevent personal injury or equipment damage.
S
ome chemical cleaning agents may be conductive and leave a residue that
may permit a build-up of conductive dust or dirt. Do not allow cleaning agents
to contact electrical components and do not spray cleaning solutions onto any
of these surfaces. Personal injury or equipment damage could occur.
To ensure grounding reliability, plug the AC power cor
grounded 3-wire hospital-grade or hospital-use outlet. Do not use extension
cords. If any doubt exists as to the grounding connection, do not operate the
equipment. Personal injury or equipment damage could occur.
Do not expose the u
nit to excessive moisture that would allow for liquid
pooling. Personal injury or equipment damage could occur.
Do not touch the patient and signal input/output parts simultaneously
Due to the risk of electrical shock hazard, only qualified personnel with
appropriate service documentation should service the unit.
To Next Page
Loading...
Need help?
General
