Bistos BT-350 User Manual

BT-350 Operation Manual
7
WARNING

Thoroughly read and understand the manual prior to use of BT-350. Failure to do so
could result in personal injury or equipment damage.
 Only properly trained personnel should use BT-350 as directed by an appropriately
qualified attending physician aware of currently known risks and benefits.
 This device has been validated with the accessories and options listed in this manual
and found to comply with all relevant safety and performance requirements
applicable to the device. It is, therefore the responsibility of that person or
organization who makes an unauthorized modification or incorporates an
unapproved attachment to the device.
 Use of accessories, transducers and cables other than those specified or provided by
the manufacturer of this equipment could result in increased electromagnetic
emissions or decreased electromagnetic immunity of this equipment and result in
improper operation.
 Use only certified accessories with the appropriate International Electrotechnical
Commission (IEC) 60601 harmonized standard.
 Medical electrical equipment needs special precautions regarding EMC and needs to
be installed and put into service according to the EMC information provided in this
manual. Portable RF communications equipment (including peripherals such as
antenna cables and external antennas) should be used no closer than 30 cm (12
inches) to any part of the device, including cables specified by the manufacturer.
Otherwise, degradation of the performance of this equipment could result.
 Use of this equipment adjacent to or stacked with other equipment should be
avoided because it could result in improper operation. If such use is necessary, this
equipment and the other equipment should be observed to verify that they are
operating normally
 Do not use in the presence of flammable anesthetics. Personal injury or equipment
damage could occur.
 Do not connect to an electrical outlet controlled by a wall switch.
 Use only patient cables and transducers supplied with the monitor. Use of any other
patient cables may result in out-of-specification performance and possible safety
hazards.
 An operator may only perform maintenance procedures specifically described in this
manual.
 Do not remove the covers of BT-350 yourself to avoid damage to the equipment and
unexpected electric shock. Only qualified Bistos service engineer must repair BT-350
or replace a component.

Check the rating of the power source compatible with the input voltage rating of the

Bistos BT-350 Specifications

General

Brand	Bistos
Model	BT-350
Category	Medical Equipment
Language	English