How to troubleshoot a Bistos BT-400 Medical Equipment unit that does not turn on?
If your Bistos Medical Equipment unit isn't turning on, here's what you can check: * First, make sure the power cord is properly plugged in. * If the power cord is correctly connected, the MAIN PCB or the power supply might be defective. In this case, have a qualified technician inspect the PCB and replace any faulty components.
What to do if some LEDs are not lit on my Bistos BT-400 Medical Equipment?
If some LEDs on your Bistos Medical Equipment are not lit, it could be due to one LED burning out, which can cause four LEDs to go off. Start by checking the connection. Identify the defective LEDs, and replace them. If needed, have a qualified technician check the LED PCB and replace it if necessary.
Why is the light source enclosure of my Bistos Medical Equipment heated more than 50??
If the light source enclosure of your Bistos Medical Equipment is heated more than 50?, it may be due to the current being adjusted too high or a broken constant current circuit. Have a qualified technician check the LED and Main PCB and replace them if necessary.
Guidelines for the proper and safe operation of the BT-400 unit.
Essential safety information and warnings to prevent hazards and ensure user safety.
Guidelines for operating the BT-400 in suitable environmental conditions.
Explanation of device symbols, warnings, and control button functions.
Details the purpose of the BT-400 and its physical features.
Describes how the BT-400 operates and the characteristics of its light source.
Lists situations where phototherapy is not recommended and included accessories.
Illustrates and describes the main components of the BT-400 system.
Step-by-step guide for assembling the BT-400 unit and its components.
Instructions on how to safely connect the BT-400 to a power source.
Details on using the control panel, display, modes, and settings.
Guidance on positioning, checking intensity, and monitoring during treatment.
Key performance criteria and technical requirements for the BT-400.
Procedures for checking light intensity and replacing LED lamps.
Guidelines for cleaning and disinfecting the BT-400 unit.
Information on how to properly dispose of the BT-400 according to regulations.
Details compliance with electromagnetic immunity standards (IEC 60601).
Information on RF emissions compliance and guidance for RF immunity.
Guidelines for maintaining safe distances from RF transmitters.
General| Frequency | 2 MHz |
|---|---|
| Display | LCD |
| Power Source | Battery |
| Type | Doppler |
| Ultrasound Frequency | 2MHz |
| Auto Shut Off | Yes |
| Measurement Method | Ultrasound Doppler |
To Next Page
