26
Figure 10 - Overload Protection
To reset this warning, switch off the unit and remove all connected devices. Switch
the unit back on again and double check with caution. If the problem persists, please
contact B&K Precision.
6.4 Upper Voltage Limit (UVL) and Upper Current Limit (UCL)
The power supply has upper voltage and upper current limit settings to prevent
accidental changes to the output settings. These values can only be set through PC
software.
If set UVL value is reached when increasing the output voltage setting, the voltage
display will show the following:
Figure 11 – Upper Voltage Limit
To Next Page
Loading...
Need help?
General
