BK Precision 9801 Programming Manual

STATus: QUEStionable:PTRansition
This command is used to edit the positive transition trigger register of operation event. The
parameter determines which bits of operation event register is 1 and will change the OPER of
status byte register to be 1.
Command syntax: STATus: QUEStionable:PTRansition <NR1>
Parameter: 0~255
Example: STATus: QUEStionable:PTRansition 128
Query syntax: STATus: QUEStionable:PTRansition?
STATus:OPERation[:EVENt]?
This command can read the parameter from operation event register. After executing this order,
operation event register is reset.
Query syntax: STATus:OPERation [:EVENt]?
Parameter: None
Returned parameter: <NR1>
Relative command: STATus: OPERation:ENABle
Bit definition of operation event register:
Bit
Position
7
6
5
4
3
2
1
0
Bit Name
Not
used
Not
used
Not
used
Not
used
WTG
SWEEP
LIST
CAL
Bit
Weight
8
4
2
1
STATus:OPERation:CONDition?
This command can read the parameter from the operation condition register. When the
parameter of operation condition register changes, the bit corresponding in operation event
register is 1.
Query syntax: STATus: OPERation: CONDition?
Parameter: None
Returned parameter: <NR1>
STATus:OPERation:ENABle
This command can set the parameter of operation event enable register. Setting parameter can
determine which bit value of operation event register is 1 and the bit will change OPER of status
byte register to be 1.
Command syntax: STATus: OPERation:ENABle <NR1>
Parameter: 0~255
Example: STATus: OPERation:ENABle 128
Query syntax: STATus: OPERation:ENABle?
Returned parameter: <NR1>
STATus:OPERation:NTRansition
This command is used to edit the negative transition trigger register of operation event. The

BK Precision 9801 Specifications

General

Brand	BK Precision
Model	9801
Category	AC Power Distribution
Language	English