BK Precision 9801 - CONFIG Commands

[SOURce:]FREQuency[:IMMediate]
This command is used to set the output frequency value.
Command syntax: [SOURce:]FREQuency[:IMMediate] <NRf>
Parameter: MIN TO MAX|MIN|MAX|DEF
Unit: Hz
Query syntax: [SOURce:]FREQuency[:IMMediate]?
Return parameter: <NRf>
[SOURce:]PHASe:STARt
This command is used to set the start phase angle.
Command syntax: [SOURce:]PHASe:STARt <NRf>
Parameter: MIN TO MAX|MIN|MAX|DEF
Unit: °
Query syntax: [SOURce:]PHASe:STARt?
Return parameter: <NRf>
[SOURce:]PHASe:END
This command is used to set the stop phase angle.
Command syntax: [SOURce:]PHASe:END <NRf>
Parameter: MIN TO MAX|MIN|MAX|DEF
Unit: °
Query syntax: [SOURce:]PHASe:END?
Return parameter: <NRf>
[SOURce:]DIMMer[:PHASe]?
This command is used to set the phase of the phase angle dimming function.
Command syntax: [SOURce:]DIMMer[:PHASe]<NRf>
Parameters: MIN TO MAX|MIN|MAX|DEF
Unit: °
Query syntax: [SOURce:]DIMMer[:PHASe]?
Parameter: None
Return parameter: <NRf>
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]
This command is used to set a voltage output of the power supply.
Command syntax: [SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude] <NRf>
Parameters: MIN TO MAX|MIN|MAX|DEF
Unit: V
Query syntax: [SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]?
Return parameter: <NRf>
2.7 CONFIG Commands