Command syntax：LIST:STEP:SD:SITe <NR1>,<NRf>
Parameter 1: 0 ~ 99
Parameter 2: Time, unit: ms
Example: LIST:STEP:SD:SIT 5, 10
Query syntax: LIST:STEP:SD:SITe? <NR1>
Query Example: LIST:STEP:SD:SIT? 2
Return Parameter: <NRf>
LIST:STEP:SD:TIMe
This command is used to set the duration of the disturbance for a single step in the list file.
Command syntax：LIST:STEP:SD:SITe <NR1>,<NRf>
Parameter 1: 0 ~ 99
Parameter 2: Time, unit: ms
Example: LIST:STEP:SD:TIM 3, 20
Query syntax: LIST:STEP:SD:TIMe? <NR1>
Query Example: LIST:STEP:SD:TIM? 2
Return Parameter: <NRf>
LIST:SAVe:BANK
This command is used to save a list file into a specified memory location.
Command syntax：LIST:SAVe:BANK <NR1>
Parameter: 0 ~ 9
Example: LIST:SAV:BANK 0
LIST:RUN:STEP:COUNt?
This command is used to query the step currently running
Query syntax：LIST:RUN:STEP:COUNt?
Parameter: None
LIST:RUN:STEP:REPeat?
This command is used to query the step currently running
Query syntax：LIST:RUN:STEP:REPeat?
Parameter: None
2.10 SWEEP Commands
SWEep:STATe
This command is used to set the state of sweep mode.
Command syntax: SWEep:STATe <string>
Parameter: < DISable|ENABle >
Example: SWE:STAT ENAB
Query syntax: SWEep:STATe?
To Next Page
Loading...
Need help?
General