BK Precision 9801 - Page 26

Return parameter: <string>
SWEep:RECall
This command is used to recall a sweep setup file.
Command syntax: SWEep:RECall <NR1>
Parameter: 0 ~ 9
Example: SWE:REC 4
Query syntax: SWEep:RECall?
Return parameter: <NR1>
SWEep:STARt:VOLTage
This command is used to edit the sweep starting voltage.
Command syntax: SWEep:STARt:VOLTage <sNRf>
Parameter: MINimum|MAXimum|<NRf>
Parameter unit: V
Example: SWE:STAR:VOLT 5
Query syntax: SWE:STAR:VOLT?
Return parameter: <NRf>
SWEep:END:VOLTage
This command is used to edit the sweep starting voltage.
Command syntax: SWEep:END:VOLTage <sNRf>
Parameter: MINimum|MAXimum|<NRf>
Parameter unit: V
Example: SWE:END:VOLT 5
Query syntax: SWE:END:VOLT?
Return parameter: <NRf>
SWEep:STEP:VOLTage
This command is used to edit the sweep voltage step.
Command syntax：SWEep:STEP:VOLTage <NRf>
Parameter : MINimum|MAXimum|<NRf>
Parameter unit: V
Example: SWE:STEP:VOLT 10.2
Query syntax: SWEep:STEP:VOLTage?
Return Parameter: <NRf>
SWEep:STEP:TIMe:UNIT
This command is used to set the sweep time unit for a single step.
Command syntax：SWEep:STEP:VOLTage <NRf>
Parameter: SECond|MINUte|HOUR
Example: SWE:STEP:TIM:UNIT SEC
Query syntax: SWEep:STEP:VOLTage?