BK Precision 9801 - SYSTEM Subsystem

parameter determines which bits in operation event register is 1 and will change the OPER bit
of status byte register to be set to 1.
Command syntax: STATus:OPERation:NTRansition <NR1>
Parameter: 0~255
Example: STATus:OPERation:NTRansition 128
Query syntax: STATus:OPERation:NTRansition?
STATus:OPERation:PTRansition
This command edits the positive transition trigger register of operation event. The parameter
determines which bits of operation event register is 1 and will change the OPER bit of status
byte register to be set to 1.
Command syntax: STATus:OPERation:PTRansition <NR1>
Parameter: 0~255
Example: STATus:OPERation:PTRansition 128
Query syntax: STATus:OPERation:PTRansition?
2.4 SYSTEM Subsystem
SYSTem:ERRor?
This command is used to read the error code and the error information.
Command syntax: SYST:ERR?
Parameter: None
Returned parameter: <NR1>,<SRD>
The following is the error code and the definition:
(101) Too many numeric suffices
(110) No input command
(114) Invalid Numeric suffix
(116) Invalid value
(117) Invalid dimensions
(120) Parameter overflowed
(130) Wrong units for parameter
(140) Wrong type of parameter
(150) Wrong number of parameter
(160) Unmatched quotation mark
(165) Unmatched bracket
(170) Invalid command
(180) No entry in list
(190) Too many dimensions
(191) Too many char
(-200) Execution error
(-221) Settings conflict
(-222) Data out of range
(-223) Too much data