(-224) Illegal parameter value
(-225) Out of memory
(-230) Data Corrupt or Stale
(-270) Macro error
(-310) System error
(-350) Too many errors [errors beyond 9 lost due to queue overflow]
(-400) Query error
(-410) Query INTERRUPTED
(-420) Query UNTERMINATED
(-430) Query DEADLOCKED
(-440) Query UNTERMINATED
(0) No error
(1) Module Initialization Lost
(2) Mainframe Initialization Lost
(3) Module Calibration Lost
(4) Eeprom failure
(5) RST checksum failed
(10) RAM selftest failed
(40) Flash write failed
(41) Flash erase failed
(213) RS-232 buffer overrun
(216) RS-232 receiver framing
(217) RS-232 receiver parity
(218) RS-232 receiver overrun
(220) Front panel uart overrun
(221) Front panel uart framing
(222) Front panel uart parity
(223) Front panel buffer overrun
(224) Front panel timeout
(225) Front Crc Check error
(226) Front Cmd Error
(401) CAL switch prevents
(402) CAL password is incorrect
(403) CAL not enabled
(404) readback cal are incorrect
(405) programming cal are incorrect
(406) Incorrect sequence of cal
(603) FETCH of data was not acquired
(604) Measurement overrange
SYSTem:VERSion?
This command is used to query the current SCPI version. The returned parameter is a string
like”YYYY.V”, in which the YYYY is the year of that version, V is the software version of that year.
Command syntax: SYST:VERS?
To Next Page
Loading...
