When all commands before this command are executed, bit OPC in standard event register will
be set to 1.
Command syntax: *OPC
Parameter: None
Query syntax: *OPC?
Returned parameter: <NR1>
*RST
This command resets the power supply to default settings.
Command syntax: *RST
Parameter: None
*SRE
This command can set the parameter of state byte enable register. Setting parameter can
determine which byte value of state byte register is 1 and the byte will set RQS of state byte
register to 1. Bit definition of state byte enable register is the same as the state byte register.
Command syntax: *SRE <NR1>
Parameter: 0~255
Query syntax: *SRE?
Returned parameter: <NR1>
*STB?
This command can read the data from status byte register.
Query syntax: *STB?
Parameter: None
Returned parameter: <NR1>
*TRG
When power supply trigger source is a command from via BUS, this command will give a trigger
signal. And its function is the same as “TRIGger” command.
Query syntax: *TRG
Parameter: None
Returned parameter: None
*SAV
This command can save the current setups of power supply to specified memory. The memory
is divided into 10 groups, each contain 0~9 (10 total) setups. Up to 100 setups can be saved in
total.
Command syntax: *SAV<NRf>
Parameter: 0~9
*RCL
This command can recall the setups you saved previously from the specified memory location.
Command syntax: *RCL<NRf>
To Next Page
Loading...
Need help?
General