BK Precision BK8510B - Page 27

27
1. Press + (Prog).
ACTIVE =0987654321
2. Press , and press enter to conrm.
ACTIVE =0987654YYY
3. Select the step that should pause during the test. When paused, press [downarrow] continue the test.
PAUSE=NNNNNNN32Y
4. Step 3 short circuit testing, press , and press to conrm.
SHORT =NNNNNNNY21
5. Set Ton for the rst step if you want to load on for 2S, press , and then press to conrm. T-on range 0-60S.
SEQ01 ON =2S
6. Set To for the rst step, if you want to load o 2S, press , and then press to conrm.
SEQ01 OFF =2S
7. Set testing delay time, 0-60S e.g. 1S, press [1].
SEQ01 P/F =1S
8. Set Ton for the second step, if you want to load 2S, press , then press Enter to conrm
SEQ02 ON =2S
9. Set To of the second step, if you need 2S, press , and then press to conrm.
SEQ02 OFF =2S
10. Set testing delay time of the second step, e.g. 1S, press
SEQ02 P/F =1S
11. Set Ton for the third step, if you want to load on 3S, press , then press to conrm
SEQ03 ON =3S
12. Set To of the third step, if you need 2S, press , then press to conrm.
SEQ03 OFF =2S
13. Set testing delay time of the third step, e.g. 2S, press .
SEQ03 P/F =2S
14. set start voltage. Please refer to “function of auto start voltage”.
AUTO START=0.000V
15. Set stop condition
STOP COMP FAILURE
Function of Auto Start Voltage:
1. Auto start=0V.
Auto test le start to run when receive a trigger signal by pressing +
name:
images/trigButton
file:
images/trigButton
state:
unknown
or providing a external trigger signal.
2. Auto start is not equal to 0V (Take 2V as an example)
In this condition the user connects the charger to the input terminals of E-load. The unit can auto start to run test
le when detect a rising edge from 0-2V. Auto start voltage is not suggested to be a big value.2V is suitable.