To Next PageTo Next PageWhy is my Black & Decker Pressure Washer leaking water from the pump?
If water leaks from the pump of your Black & Decker Pressure Washer, make sure that all fittings are tight. If the water seals are damaged or worn, contact your local dealer.
What to do if Black & Decker BEPW1750 has no detergent?
If there's no detergent, the container might be empty (add more detergent), the bottle or suction tube may not be properly connected (check connections), the detergent could be too thick (use detergent recommended for pressure washers only), the filter on the suction tube could be clogged (run warm water through it), the suction tube might be damaged or clogged (remove obstruction or replace it), or the discharge nozzle is obstructed (blow out or remove debris).
Why Black & Decker BEPW1750 Pressure Washer unit does not reach high pressure?
The unit may not reach high pressure if the water faucet isn't fully turned on (open the water valve fully), the water inlet filter is clogged (remove and rinse to clean), the nozzle is worn (replace with a new nozzle), the pump is sucking air (check that hoses and fittings are airtight, turn OFF the machine and purge the pump by squeezing the trigger gun until a steady flow of water emerges from the nozzle), the water supply is restricted (check the water hose for kinks, leaks, and blockages). Also, the unit may not be properly self-primed.
What causes output pressure varies high/low on Black & Decker BEPW1750 Pressure Washer?
General| Power Source | Electric |
|---|---|
| Maximum Pressure | 1750 PSI |
| Water Flow Rate | 1.2 GPM |
| Flow Rate | 1.2 GPM |
| Weight | 17.2 lbs |
| Hose Length | 20 ft |
| Cord Length | 35 ft |
