Page 18
877-877-2269 | blackbox.com
Chapter 4: Operation
Accessing through Serial
1. Using the client, select “serial” and enter “9600” for the speed (baud rate).
2. No username or password is required.
Set the COM number, baud rate, data bit, stop bit, and parity bit correctly so you can
send commands in the Command Sending Area of the screen.
NOTE: To control the AVS-HDB-WPTX via an RS-232 port, configure the communication
protocol parameters as: Baud rate: 9600; Data bit: 8; Stop bit: 1; Parity bit: none.
To Next Page
Loading...
Need help?
General