724-746-5500 | blackbox.com
724-746-5500 | blackbox.com
Page 29
Chapter 2: System Configuration
2.5.2 Log
This section describes how to display the System Log Information for the switch.
Web Interface
To display the log configuration in the Web interface:
1. Click Syslog, Log.
2. Display the log information.
Figure 2-11. The System Log Information screen.
Parameter Description
• Auto-refresh: To set the switch to auto-refresh the log information, check “Auto-refresh.”
• Level: level of the system log entry. The following level types are supported:
- Information level of the system log.
- Warning: Warning level of the system log.
- Error: Error level of the system log.
- All: All levels.
• ID: ID (>= 1) of the system log entry.
• Time: It will display the log record by device time. The time of the system log entry.
• Message: It will display the log detail message. The message of the system log entry.
• Icons, upper right of screen (Refresh, clear,….): Click these to refresh the system log or clear them manually. Arrow
functions enable you to navigate to the first, prior, next, or last page.
LGB110 8 A
To Next Page
Loading...
Need help?
General